Selve commeo WS - Initial Operation; Programming the Hand-held Transmitter

GB
31
GB
Initial operation
6. Initial operation
Transmitter
To set the threshold values for wind and sun a hand-held transmitter commeo Multi
Send or commeo Send WS 10 is required.
If a hand-held transmitter commeo Multi Send or commeo Send WS 10 is already
programmed in the receiver, continue with point 6.2.
6.1. Programme the hand-held transmitter into the motor
The end limit positions in the motor or the runtime in the receiver have to be
set!
1. Interrupt the power on the receiver (>1 second).
2. Set the corresponding channel on the hand-held transmitter that will be
assigned to this motor. Use the buttons  or  of the hand-held transmit-
ter.
• The number of the channel will be shown on the display of the hand-held
transmitter (Multi Send).
• The channel will be signalized by the LED display (Send WS 10).
3. Press the SELECT button on the back side of the hand-held transmitter
for 3 seconds.
• The motor at which previously the power was interrupted for a short time,
jerks briefly. The status LED slowly flashes orange.
4. Press the PROG button on the back side of the hand-held transmitter for
1 second.
• The LED on the hand-held transmitter lights green for a short time.
5. Press the SELECT button on the back side of the hand-held transmitter
for 3 seconds.
• The status LED no longer flashes. The motor can only be manually oper-
ated by the assigned channel number.