Selve commeo WS - Sensor Saving; Saving the Sensor to Receiver; Sensor Deletion; Deleting the Sensor

32
GB
Initial operation
6.2. Save the sensor into the receiver by using the hand-held transmitter
3 s
1. Press the PROG button on the hand-held transmitter for 3 seconds.
• The status LED on the hand-held transmitter lights orange and then
green for a short time.
• The motor/receiver is ready to be programmed for 4 minutes.
<1 s
2. Press the PROG button on the commeo Sensor WS/WSRF shortly for
1 second.
• The status LED on the sensor lights green for a short time.
• The commeo Sensor WS/WSRF is saved in the motor/receiver. By using
the toggle button the receiver can be moved.
6.3. Delete sensor
3 s
1. Press the PROG button on the hand-held transmitter for 3 seconds.
• The status LED on the hand-held receiver lights green.
<3 s
2. Press the PROG button on the commeo Sensor WS/WSRF for 3 sec-
onds.
• The status LED on the sensor lights orange, then red.
• The commeo Sensor WS/WSRF is no longer saved in the motor/receiver.
Moving the receiver by using the toggle button is no longer possible.