Selve commeo WS - Setting Wind Threshold (Send WS 10); Using commeo Send WS 10

GB
37
GB
Automatic functions/Protective functions
Wind threshold value: Setting with the hand-held transmitter commeo Send WS 10
Select the receiver or rather the group by using the channel
select buttons
 or  to modify the corresponding threshold
values.
Afterwards press the WIND button on the back side of the
hand-held transmitter for 3 seconds.
• The status LED flashes red with high frequency.
• Programmed motors make a short up and down movement.
• Afterwards the status LED flashes red with reduced frequen-
cy for 2 minutes.
In case several motors are programmed onto a channel:
Press the SELECT button several times in order to select the
individual receiver.
• With the group control lights (LED’s) the currently set wind
threshold will be shown by means of the quantity and colours
of the LED’s.
• The wind threshold can be modified by pressing the
 or 
button.
Press the WIND button on the back side of the hand-held
transmitter for 3 seconds.
• The set value is now saved and the hand-held transmitter is
ready for operation.
Note:
After 2 minutes without another modification at the commeo Send WS 10 the set wind
threshold will be saved automatically.
3 s
3 s