Sena 10U - Advanced Selective Pairing

10U
25
English
1. To pair the HFP device, press and hold the Front Button for 5 seconds
until the red LED ashes red rapidly and you hear voice prompt,
“Intercom pairing”.
2. Within 2 seconds, tap the Rear Button again, then the LED ashes
blue rapidly and you will hear a voice prompt, “Second mobile
phone pairing”.
3. Search for Bluetooth devices on the HFP device. Select the Sena 10U
in the list of the devices detected on the HFP device.
4. Enter 0000 for the PIN. Some HFP devices may not ask for the PIN.
5. The HFP device conrms that the pairing is completed and the 10U is
ready to use. You will hear a voice prompt, “Your headset is paired”.
Note:
1. If the GPS is also your preferred Bluetooth stereo music source, you can
pair the GPS to the 10U by following the simple procedure in section 5.1,
“Mobile Phone Pairing Mobile Phone, Bluetooth Stereo Device”.
2. You have to use a motorcycle specific GPS, which transmits turn-by-turn
voice instructions to the headset by Bluetooth. Most automotive GPS
systems do not have this feature.
3. The Sena SR10 is a Bluetooth two-way radio adapter for group
communication, and uses Hands-Free Profile. The incoming audio from
the two-way radio via SR10 is heard in the background while having an
intercom conversation or a mobile phone call.
4. The GPS navigation or a radar detector could be connected to the SR10
by wire. The GPS voice instruction or the radar detector alarm is also
heard in the background via SR10 while having an intercom conversation
or a phone call. Please refer to the SR10 User’s Guide for details.
5.3 Advanced Selective Pairing: A2DP Stereo or Handsfree
When you are using a smartphone, sometimes you may need to
selectively uses the 10U for A2DP stereo music only or for mobile phone
Hands-Free only. These instructions are for advanced users who want to
pair the 10U to their smartphones with only one selective prole: A2DP for
stereo music of HFP for phone calls.