Sena 10U - Configuration Settings Menu; Voice Prompt Navigation

10U
45
English
13 CONFIGURATION SETTING
You can set the conguration of the 10U by the voice menu instruction
described below.
1. To enter into voice conguration menu, press and hold the Front
Button for 12 seconds until the LED shows solid blue and you
hear high toned double beeps. You will also hear a voice prompt,
“Conguration menu”.
2. Move the Joystick up or down to navigate between the menus. You
will hear voice prompts for each menu item as below.
3. You can enable the feature or execute the command by tapping the
Rear Button, or disable the feature by tapping the Front Button.
4. If any button is not pressed within 10 seconds, the 10U will exit the
conguration and go back to stand-by mode.
5. If you want to exit the conguration immediately, move the Joystick up
or down until you hear a voice prompt, “Exit conguration”, and tap
the Rear Button.
Function Handlebar Remote Headset
Enter conguration
menu
Press the Front Button for
12 seconds
Press the (+) Button for
10 seconds
Navigate between
menus
Move the Joystick up
or down
Tap the (+) Button
Execute Tap the Rear Button Tap the (–) Button
Enable Setting Tap the Rear Button Tap the (–) Button
Disable Setting Tap the Front Button Tap the (–) Button
The voice prompt for each menu item is as below:
(1) Speed dial
(2) Audio Boost
(3) VOX phone
(4) VOX intercom
(5) Voice prompt
(6) RDS AF setting
(7) Sidetone
(8) Noise control
(9) Delete all pairings
(10) Remote control pairing
(11) Universal intercom pairing
(12) Factory reset
(13) Exit conguration