Sena 10U - RDS AF Setting; Sidetone Feature; Advanced Noise Control; Delete All Bluetooth Pairings

10U
49
English
13.6 Enabling/Disabling RDS AF
Voice Prompt
“RDS AF setting”
Factory Default Disable
Enable Tap the Rear Button
Disable Tap the Front Button
RDS AF allows a receiver to re-tune to the second frequency location
when the rst signal becomes too weak. With RDS AF enabled on the
receiver, a radio station with more than one frequency can be used.
13.7 Enabling/Disabling Sidetone
Voice Prompt
“Sidetone”
Factory Default Disable
Enable Tap the Rear Button
Disable Tap the Front Button
Sidetone is audible feedback of your own voice. It helps you to naturally
speak at the correct level according to varying helmet noise conditions.
If this feature is enabled, you can hear what you are speaking during an
intercom conversation or a phone call.
13.8 Enabling/Disabling Advanced Noise Control™
Voice Prompt
“Noise control”
Factory Default Enable
Enable Tap the Rear Button
Disable Tap the Front Button
When Advanced Noise Control is enabled, the background noise is
reduced during an intercom conversation. When it is disabled, the
background noise is mixed with your voice during intercom.
Note:
If you use your 10U with the Bluetooth Audio Pack for GoPro, you can
enable or disable this feature only during Normal Audio Recording Mode.
This feature is automatically disabled while in Ultra HD (UHD) Audio Mode.
13.9 Delete All Bluetooth Pairing Information
Voice Prompt
“Delete all pairings”
Factory Default N/A
Execute Tap the Rear Button
To delete all Bluetooth pairing information of the 10U, move the Joystick
up or down until you hear a voice prompt, “Delete all pairings”, and tap
the Rear Button to conrm.