Sena 10U - Handlebar Remote Disconnection; Quick Reference for Sena 10 U Operation; Using the Handlebar Remote

10U
54
15.5 Handlebar Remote Disconnection
If your Handlebar Remote becomes disconnected with your headset,
check if they have enough battery power or if they are not separated by
more than 10 meters. If they are low on battery, recharge and try again. If
they are too far apart, bring them closer. If they are still disconnected, try
pairing them again by following the procedure below.
1. Turn on the 10U and the Handlebar Remote.
2. Press the (+) Button for 10 seconds to enter the conguration menu.
Tap the (+) Button until you hear a voice prompt saying, “Remote
control pairing”. Press the (−) Button to enter into Remote Control
Pairing mode and the red LED will ash rapidly and you will hear
multiple beeps.
3. On the Handlebar Remote, press the Rear Button for 5 seconds until
its LED ashes red and blue. The 10U will automatically perform
pairing with the Handlebar Remote in pairing mode. The Handlebar
Remote’s LED will ash blue every two seconds and you will hear
a voice prompt, “Remote control connected” when they are
successfully connected.
16 OPERATION QUICK REFERENCE
16.1 Using the Handlebar Remote
Type Function Button Command LED Beep
Basic
Function
Power on Tap the Front Button – –
Power off
Press the Front Button and the
Joystick for 2 seconds
– –
Volume
adjustment
Move the Joystick up or down – –
Mobile
Phone
Mobile phone
pairing
Press the Joystick for 5 seconds
Blue & red
alternatively
flashing
High tone
multiple beeps
Second
mobile phone
pairing
Press the Front Button for 5 seconds Red flashing Multiple beeps
Tap the Rear Button within 2 seconds
Answer & end
phone call
Tap the Rear Button – –
Voice dial Tap the Rear Button – –
Speed dial Double Tap the Rear Button –
Midtone single
beep
Reject
incoming call
Press the Front Button for 2 seconds – –