Sena 10U - Mobile Phone, GPS, and SR10 Operations; Mobile Phone Call Handling

10U
28
6 MOBILE PHONE, GPS, SR10
6.1 Mobile Phone Call Making and Answering
1. When you have an incoming call, simply tap the Rear Button or the
Front Button to answer the call.
2. You can also answer the incoming call by loudly speaking any word
of your choice if Voice Activated Phone Answering (VOX Phone) is
enabled, unless you are connected to intercom.
3. To end a call, tap the Rear Button or press the Front Button for 2
seconds until you hear a beep, or wait for the called person to end
the call.
4. To reject a call, press the Front Button for 2 seconds until you hear a
beep while the phone is ringing.
5. There are several ways to make a phone call:
– Enter numbers on your mobile phone’s keypad and make a call.
Then the call is automatically transferred to the headset.
– Tap the Rear Button in stand-by mode to activate the voice dialer
of your mobile phone. For this, the voice dialing function must be
available on the mobile phone. Refer to your mobile phone manual
for further instruction.
Function Handlebar Remote Headset
Mobile Phone
Pairing
Press the Joystick for
5 seconds
Press the (–) Button for
12 seconds
Second Mobile
Phone Pairing
Press the Front Button for
5 seconds
Press the (–) Button for
12 seconds
Tap the Rear Button
Tap the (+) Button three
times
Media Selective
Pairing
Press the Joystick for
5 seconds
Press the (–) Button for
12 seconds
Tap the Front Button Tap the (+) Button twice
Phone Selective
Pairing
Press the Joystick for
5 seconds
Press the (–) Button for
12 seconds
Tap the Rear Button Tap the (+) Button
Intercom Pairing
Press the Front Button for
5 seconds
Press the (–) Button for
8 seconds
Tap the Front Button of any
one of the two headsets
Tap the (–) Button of any one
of the two headsets
Button Operation Table for Bluetooth Pairing