Sena 10U - Remote Control Pairing; Universal Intercom Pairing Configuration; Factory Reset Option; Exit Configuration Menu

10U
50
13.10 Remote Control Pairing
Voice Prompt
“Remote control pairing”
Factory Default N/A
Execute Tap the Rear Button
To enter into Remote Control Pairing mode, move the Joystick up or down
until you hear a voice prompt, “Remote control pairing”. Then press the
Rear Button to enter into Remote Control Pairing mode. The headset will
automatically exit from the conguration menu.
Note:
If you cannot use the Handlebar Remote to enter into Remote Control
Pairing, please refer to section 15.5 to enter into Remote Control Pairing
using the headset control buttons.
13.11 Universal Intercom Pairing
Voice Prompt
“Universal intercom pairing”
Factory Default N/A
Execute Tap the Rear Button
To enter into Universal Intercom Pairing mode, move the Joystick up or
down until you hear a voice prompt, “Universal intercom pairing”. Then
press the Rear Button to enter into Universal Intercom Pairing mode. The
headset will automatically exit from the conguration menu.
13.12 Factory Reset
Voice Prompt
“Factory reset”
Factory Default N/A
Execute Tap the Rear Button
To restore factory default settings on the 10U, move the Joystick up or
down until you hear a voice prompt, “Factory reset”, and tap the Rear
Button to conrm. The 10U powers off with a voice prompt, “Headset
reset, goodbye”.
13.13 Exit Voice Conguration Menu
Voice Prompt
“Exit conguration”
Factory Default N/A
Execute Tap the Rear Button
To exit voice conguration menu and get back to stand-by mode, move the
Joystick up or down until you hear a voice prompt, “Exit conguration”,
and tap the Rear Button to conrm.