Sena 10U - Page 35

10U
35
English
8.3.2 Ending Four-way Intercom
As same in the case of three-way intercom, you can completely get out
of the four-way conference intercom or just disconnect a single intercom
connection.
1. Press the Front Button for 1 second until you hear a beep to terminate
four-way conference intercom. It terminates the intercom connections
between you (A), and your intercom friends (B) and (C).
2. Tap or double tap the Front Button to disconnect the intercom
connection with one of the two intercom friends accordingly. However,
when you disconnect the second friend (C) by double tapping the
Front Button, you will be disconnected with the third participant (D) as
well. This is because the third participant (D) is connected with you
via the second friend (C).
Front Button Operation Result
Press for 1” Disconnect (B), (C) & (D)
Single tap Disconnect (B)
Double tap Disconnect (C) & (D)
End Four-way Intercom
Function Handlebar Remote Headset
Call rst
intercom friend
Tap the Front Button
Press the (–) Button for
1 second until you hear
a single beep
Call second
intercom friend
Double tap the Front Button
Press the (–) Button
for 2 seconds until you
hear double beeps
Call third
intercom friend
Triple tap the Front Button
Press the (–) Button
for 3 seconds until you
hear triple beeps
End Two-way
intercom
Tap the Front Button
Press the (–) Button for
1 second
End all
intercoms
Press the Front Button for
1 second
Press the (–) Button for
5 seconds
Button Operation Table for Intercom