Sencore OmniHub CMP201 User Manual

OmniHub CMP201– User Manual
Page 46 of 103
Audio Encoder
Details
Range
Audio Encoder
Details
Range
Audio Type
MPEG1_Layer2
AC3
AAC
Audio PID
32~8190
Audio Bit rate
(Kbps)
32~192
Volume(dB)
-20~20
Delays
(ms)
-2000~2000
Shelter
Parameters
Range
Shelter
Parameters
Range
Shelter
Enable/Disable
X
0~1920 (Dual)
Y
0~1080 (Dual)
Width
2~1920 (Dual)
Height
2~1080 (Dual)
Color
White/Black/Blue/Green/
Red
3.3.7.3 IP Output
This feature is specifically for single program encoding and IP output directly. By using this way
to output, it will not occupy baseboard multicast bandwidth.
If you want to use IP output channel in the encoder module and baseboard IP module at
same time, you should avoid the multicast IP addresses confliction. If there are two same IP
addresses enable meantime, all the multicast video will be affected.
• Destination IP Address and Destination Port: Using for multicast IP addresses or
unicast IP addresses and ports.
• Enable Destination MAC: Generally, you do not need to enable this option. This is
reserved for exceptional case when the unicast stream cannot be received by using
unicast IP addresses, you can enable destination MAC and streaming out by setting
Destination MAC.
• Advance Setting (only available in CE2-HDMI-00):
The second eth is reserved for you to output IP stream in an another different VLAN, enable the
second eth and set IP Address, Subnet Mask, Default Gateway in the same segment of the
Unicast IP (the another different VLAN), you can output Unicast stream to the another VLAN.

Sencore OmniHub CMP201 Specifications

General

Brand	Sencore
Model	OmniHub CMP201
Category	Media Converter
Language	English