OmniHub CMP201– User Manual
Page 69 of 103
On the Left side, you will see the list of TS where there are output service. If the TS or Channel
are enabled but no Service Output. It will not be listed here.
You will also see the Original Network ID and TS ID where you can modify the details and below
will be the list of the service in the Selected TS. Initially, TS 1 is selected when you first select
the Service Configuration tab.
Clicking on the Program name under the TS will show the Programs Basic Parameter where
you can modify each detailed.
Clicking on the con icon will show you the NIT setting where you can create and add NIT
Network and NIT Stream.
To Next Page
Loading...
Need help?
General
