Sencore OmniHub CMP203 - Page 60

OmniHub CMP203– User Manual
Page 60 of 109
P Frame: 18~47
IBP
P Frame: 8~23
Audio Encoder Details
Range
Audio
Encoder
Details
Range
Audio Type
AC3
MPEG1_Layer2
MPEG2_AAC
MPEG4_AAC
Audio Source
HDMI
Analog
None
Volume
0~8
Audio PID
32~8190
Audio Bit Rate(Kbps)
128~384 (AC3)
64~384(MPEG1_Layer2/
MPEG2_AAC/ MPEG4_A
AC)
The CE2-HDMI-02C module support total two sets of audio and video input. Each set
includes 1 HDMI port/1 component port and1 analog port.
If video comes from HDMI, there are three options for encoding dual audio:
1. One audio comes from HDMI and the another comes from analog; the encoding
format can be the same or different;
2. Dual audio all come from HDMI with the same content and the encoding format
can be the same or different;
3. Dual audio all come from analog input with the same content, encoding format
can be the same or different.
If video comes from the component, there is only one choice for encoding dual
audio:
Dual audio all come from analog input with the same content and the encoding
format can be the same or different.
3.3.9.3 IP Output
Please see CE2-HDMI-00 IP Output at page 48 for reference.
3.3.9.4 EAS Settings
Settings for the EAS feature need to be made on the encoder module so that when the
EAS source is triggered, the Audio and Video from the encoder will be replace by the
Audio and Video from AES module.
EAS will ask you the Source Multicast Address, Command port and Data port. This
information can be seen in the EAS page