SP395 SoundPro Audio Integrator Form7492 Operation Manual
ii
WARNING
PLEASE OBSERVE THESE SAFETY PRECAUTIONS
There is always a danger present when using electronic test equipment.
Unexpected voltages can be present at unusual locations in defective
equipment and distribution systems. Become familiar with the equipment
with which you are working, and observe the following safety precautions.
Every precaution has been taken in the design of the SoundPro SP395 Audio
Integrator to insure that it is as safe as possible. However, safe operation
depends on you, the operator.
1. Never exceed the limits of the SoundPro SP395 as given in the specifications
section or other special warnings provided in this manual.
2. Always be sure that your equipment is in good working order. Broken or
frayed test leads or cables can be extremely dangerous and may expose you to
high voltages.
3. Remove test leads immediately following measurements to reduce the
possibility of shock.
4. Do not work alone when working under hazardous conditions. Always have
another person available in case of an accident.
5. Never assume that a cable shield is at earth ground potential. Both static
and electrical voltages can be present on a cable’s sheath.
6. Always follow standard safety procedures.
Sencore reserves the right to make changes in specifications and other information contained in this publication
without prior notice, and the reader should in all cases consult Sencore to determine whether any such changes have
been made. This manual may not be reproduced, and is intended for the exclusive use of Sencore users.
When in doubt, be careful.
To Next Page
Loading...
