Sentec SDM - 2 The Sentec Digital Monitoring System (Sdms); Components; Table 2 Components of the SDMS

2 The SenTec Digital Monitoring System (SDMS)
SenTec Digital Monitoring System
11
2 The SenTec Digital Monitoring
System (SDMS)
2.1 Components
The SenTec Digital Monitoring System (SDMS) comprises the following main
components:
Table 2 Components of the SDMS
REF
Product
SDM
SenTec Digital Monitor (including mains power cord)
SDMs with firmware version SMB SW-V08.00/ MPB SW-V06.00 are available
with/without factory preconfigured PO2-option.
VS-A/P/N
V-Sign™ Sensor 2 (for PCO2, SpO2/PR monitoring)
OV-A/P/N
OxiVenT™ Sensor (for PCO2, PO2, SpO2/PR monitoring)
AC-YYY
Digital Sensor Adapter Cable (to connect VS-A/P/N or OV-A/P/N to SDM; YYY=150,
250, 750 cm)
EC-MI
Ear Clip (to apply SenTec TC Sensors at earlobe of patients with mature/ intact skin)
MAR-MI
Multi-Site Attachment Ring MAR-MI (to apply SenTec TC Sensors to patients with
mature/ intact skin)
MAR-SF
Multi-Site Attachment Ring MAR-SF (to apply SenTec TC Sensors to patients with
sensitive/ fragile skin)
SA-MAR
Staysite™ Adhesive for the Multi-Site Attachment Rings (attaches complementary
the MAR-SF/MI to the skin with an additional adhesive film)
GEL-04
Contact Gel (contact liquid to apply SenTec TC Sensors to the patient)
MC-R
Membrane Changer (to change the membrane of SenTec TC Sensors)
MC-I
Membrane Changer Insert (separately bagged, single-use Inserts for the MC-R)
GAS-0812
Service Gas (needed to calibrate SenTec TC Sensors)
V-STATS_CD
V-STATS™ (PC based Trend Data Download/ Analysis, Remote Monitoring, and
Configuration Software for SenTec Digital Monitors)
Note:
The components listed above do not necessarily correspond to the scope of
delivery. Please refer to SenTec’s Webpage (www.Sentec.com/products) for
additional information and other available accessories.