1 Introduction
SenTec Digital Monitoring System
1 Introduction
This Manual provides information on
maintenance and safety and functionality tests for the SenTec Digital
Monitoring System (SDMS) intended for qualified personnel only (
see
section 3
);
troubleshooting for the SDMS (
see section 4
). The troubleshooting list covers
three levels of recommended troubleshooting procedures a) for the operator,
b) for qualified personnel, and c) for SenTec authorized technicians only;
repair procedures that do not require opening the cover of the SDM intended
for qualified personnel only (
see section 5
).
Repairs that require opening the SDM cover are described within SenTec`s
Repair Manual for the SDMS
(which is distributed to SenTec authorized
service personnel only). Within this manual, activities described as “for
SenTec authorized service technicians only” refer to activities described in
detail within the
Repair Manual for the SDMS
(HB-005755).
This manual must be read carefully prior performing service or repairs.
Section
1.2, "Safety Information"
must be read and understood.
This Manual contains confidential information. The contents of this
document may not be reproduced in any form or communicated to any third
party without the prior written consent of SenTec AG.
To Next Page
Loading...
