Sentec SDM - Sensor Application: MAR;e-MI or MAR;e-SF; Applying the Sensor with MAR;e-MI;SF

SenTec Digital Monitoring System iii
PI Pulsation Index
PO2 Used to display/label tcPO2 on the SDM and – unless explicitely stated otherwise -
throughout this manual
POST Power-On Self-Test
RO Responsible Organization
PR Pulse rate
RHP Relative Heating Power
RMI Remote monitoring interrupted
SaO2 Arterial oxygen saturation
SDM SenTec Digital Monitor
SDMS SenTec Digital Monitoring System
SpO2 Functional oxygen saturation of arterial hemoglobin as measured with a pulse
oximeter
TC Transcutaneous
tcPCO2 Transcutaneous carbon dioxide partial pressure, i.e. an estimate of PaCO2 calculated
from the measured PcCO2 and displayed/labeled on the SDM and - unless explicitly
stated otherwise - throughout this manual as ‘PCO2’
tcPO2 Transcutaneous oxygen partial pressure, i.e. an estimate of PaO2 calculated from the
measured PcO2 and displayed/labeled on the SDM and - unless explicitly stated
otherwise - throughout this manual as ‘PO2’
VOM V-CareNeT™ Only Mode