Servomex SERVOPRO - Page 168

SERVOPRO NOx Analyzers Page
167
 Scan commands (Axxx)
 Control commands (Sxxx)
 Configuration commands (Exxx)
SCAN COMMANDS
AAEG: Verifying Span-Point Deviation During Auto Calibration
Command Response Description
_AAEG_K0 _AAEG_s_M1_z.z_da_dr
_M2_z.z_da_dr
_M3_z.z_da_dr
_M4_z.z_da_dr
_02_z.z_da.dr
Verifying deviations of ranges M1 to M4 and
O
2
with O
2
option from span point stored
after auto calibration.
Values: measured value (z.z), absolute dev
(da), relative dev (dr).
AANG: Verifying Zero-Point Deviation During Auto Calibration
Command Response Description
_AANG_K0 _AANG_s_M1_z.z_da_dr
_M2_z.z_da_dr
_M3_z.z_da_dr
_M4_z.z_da_dr
_02_z.z_da_dr
Verifying deviations of ranges M1 to M4 and
O2 with O2 option from zero point stored
after auto calibration.
Values: measured value (z.z), absolute dev
(da), relative dev (dr).
AAOG: Applied Offsets and Gains
Command Response Description
_AAOG_K0_ _AAOG_s_M1_z.z_y.y
_M2_z.z_y.y
_M3_z.z_y.y
_M4_z.z_y.y
_O2_z.z_y.y
Offset and gain of ranges M1 to M4 and O
2
with O
2
option.
z.z: Offset
y.y: Gain