SERVOPRO NOx Analyzers Page
After all the changes have been made, you must choose one of the following:
(Hourly), (Daily) or (Weekly) to save your changes. If this is not done, the
selected changes will not be made and the analyzer will revert to the previous settings.
To change Timed Auto Calibration to on or off, press (Timed Cal On/Off). A
submenu will open with two choices. Press to turn Timed Cal On, or press to
turn Timed Cal Off. Selecting or will bring you back to the AutoCal Schedule
screen. The current setting is shown on the right side of the menu after the (. . .). In the
example above the mode is OFF: Timed Cal On/Off . . . Off.
To Next Page
Loading...
