SEW-Eurodrive MAXOLUTION MAXO-MS - Service; Waste disposal

6
Service
Waste disposal
Assembly and Operating Instructions – MAXO-MS/M/SM-GIOP Sensor Module
27
6 Service
6.1 Waste disposal
Dispose of the product and all parts separately in accordance with their material struc-
ture and the national regulations. Put the product through a recycling process or con-
tact a specialist waste disposal company. If possible, divide the product into the follow-
ing categories:
• Iron, steel or cast iron
• Stainless steel
• Magnets
• Aluminum
• Copper
• Electronic parts
• Plastics
The following materials are hazardous to health and the environment. These materials
must be collected and disposed of separately.
• Oil and grease
Collect used oil and grease separately according to type. Ensure that the used oil
is not mixed with solvent. Dispose of used oil and grease correctly.
• Screens
• Capacitors
Waste disposal according to WEEE Directive2012/19/EU
This product and its accessories may fall within the scope of the country-specific appli-
cation of the WEEE Directive. Dispose of the product and its accessories according to
the national regulations of your country.
For further information, contact the responsible SEW‑EURODRIVE branch or an au-
thorized partner of SEW‑EURODRIVE.
26868113/EN – 03/2021