10
Operating Instructions – MOVITRAC® LT Option Cards
2
Transport
Safety Notes
2.5 Transport
Immediately upon receipt, inspect the shipment for any damage that may have occurred
during transportation.
Never install or start up damaged products. In the event of damage please submit a
complaint to the transport company immediately.
2.6 Installation / assembly
The units must be installed and cooled according to the regulations and specifications
in this documentation.
Protect the frequency inverters from excessive strain. Do not twist any components and
do not modify the insulation spaces. Do not touch any electronic components or
contacts.
Frequency inverters contain components that can easily be damaged by electrostatic
energy and improper handling. Electric components must not be mechanically damaged
or destroyed.
The unit meets all requirements for reliable isolation of power and electronics
connections in accordance with UL508. All connected circuits must also satisfy the
requirements for reliable isolation so as to guarantee reliable isolation.
Take suitable measures to ensure that the connected motor does not start up
automatically when the inverter is switched on. To do this, connect binary inputs DI01
through DI03 to GND / 0V.
The following applications are prohibited unless the unit is explicitly designed for such
use:
• Use in potentially explosive atmospheres.
• Use in environments with harmful substances:
– Oils
–Acids
– Gases
– Vapors
–Dust
– Radiated interference
– Other harmful environments
• Use subject to mechanical vibration and shock loads in excess of the requirements
in EN 50178.
• Use in non-stationary applications which are subject to mechanical vibration and
impact loads in excess of the requirements in EN 61800-5-1.
• If the inverter or its accessories perform safety functions which have to guarantee the
protection of machinery and people.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...