Operating Instructions – MOVITRAC® LT Option Cards
9
2
Target group
Safety Notes
2.3 Target group
Any mechanical work may only be performed by adequately qualified personnel.
Qualified personnel in this context are persons who are familiar with the setup,
mechanical installation, trouble shooting and maintenance for this product. Further, they
are qualified as follows:
• Training in mechanical engineering, e.g. as a mechanic or mechatronics technician
(final examinations must have been passed).
• They are familiar with these operating instructions.
Any electronic work may only be performed by adequately qualified electricians.
Qualified electricians in this context are persons who are familiar with the electronic
installation, startup, trouble shooting and maintenance for this product. Further, they are
qualified as follows:
• Training in electrical engineering, e.g. as an electrician or mechatronics technician
(final examinations must have been passed).
• They are familiar with these operating instructions.
All work in further areas of transportation, storage, operation and waste disposal may be
carried out only by persons who are trained appropriately.
2.4 Designated use
Frequency inverters and their accessories are components for controlling asynchronous
AC motors. Frequency inverters are components intended for installation in electrical
systems or machines. Never connect capacitive loads. Operation with capacitive loads
results in over voltages and may destroy the unit.
The following standards apply, if the frequency inverters are marketed in the EU / EFTA:
• In case of installation in machines, startup of the drive inverters (meaning the start of
proper use) is prohibited until it is determined that the machine meets the require-
ments stipulated in the EC Directive 98/37/EC (machine directive); observe
EN 60204.
• Startup (i.e. the start of designated use) is only permitted under observance of the
EMC (2004/108/EC) directive.
• The frequency inverters comply with the requirements of the Low Voltage Directive
2006/95/EC. The harmonized standards of the EN 61800-5-1/DIN VDE T105 series
in connection with EN 60439-1/VDE 0660 part 500 and EN 60146/VDE 0558 are
applied to these frequency inverters.
Observe the technical data and the connection requirements specified on the nameplate
and the operating instructions.
2.4.1 Safety functions
Frequency inverters from SEW-EURODRIVE must not perform any safety functions
unless the inverters are subordinate to other safety systems.
Use higher-level safety systems to ensure protection of equipment and personnel.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...