SEW DHE41B - Mounting and Installation Instructions; Mounting Options and Procedures

14
Manual – MOVI-PLC® advanced DHE41B/DHF41B/DHR41B Controller
4
Mounting options for the MOVI-PLC® advanced DH.41B controller
Mounting/Installation Instructions
4 Mounting/Installation Instructions
4.1 Mounting options for the MOVI-PLC
®
advanced DH.41B controller
Observe the following mounting instructions:
4.2 Mounting MOVI-PLC
®
advanced DH.41B in MOVIDRIVE
®
MDX61B
• The MOVI-PLC
®
advanced DHE41B controller must be plugged into the fieldbus slot
of the MOVIDRIVE
®
MDX61B. If the fieldbus slot is not available, you can plug the
DHE41B option into the expansion slot.
• The MOVI-PLC
®
advanced DHF41B/DHR41B controller must be plugged into the
expansion slot of the MOVIDRIVE
®
MDX61B. It cannot be installed in MOVIDRIVE
®
MDX61B size 0.
Before you begin Observe the following notes before installing or removing the MOVI-PLC
®
advanced DH.41B controller:
• Disconnect the drive inverter from power. Switch off the DC 24 V and the line voltage.
• Take appropriate measures to avoid electrostatic charges (use discharge strap, con-
ductive shoes, etc.) before touching the MOVI-PLC
®
advanced DH.41B.
• Before installing the MOVI-PLC
®
advanced DH.41B controller, remove the keypad
and the front cover.
• After installing the MOVI-PLC
®
advanced DH.41B controller, replace the keypad
and the front cover.
• Keep the MOVI-PLC
®
advanced DH.41B controller in its original packaging until im-
mediately before you are ready to install it.
• Hold the MOVI-PLC
®
advanced DH.41B controller by its edges only. Do not touch
any components.
• Never place the MOVI-PLC
®
advanced DH.41B controller on a conductive surface.
NOTES
• You can insert the MOVI-PLC
®
advanced DH.41B controller in the
MOVIDRIVE
®
MDX61B inverter, but not in the MOVIDRIVE
®
MDX60B inverter.
• Option cards can only be installed or removed for MOVIDRIVE
®
MDX61B
drive inverters sizes 1 to 6.
• Only SEW-EURODRIVE engineers may install or remove option cards for
MOVIDRIVE
®
MDX61B size 0 drive inverters.
• Only SEW-EURODRIVE engineers may install or remove MOVI-PLC
®
advanced DH.41B controllers for MOVIAXIS
®
as well as install MOVI-PLC
®
DH.41B/UOH..B compact controllers.