Sharp AR-505 - Key Operator Code Number: Factory Setting

8-33
CHAPTER8
KEY OPERATOR CODE NUMBER:
FACTORY SETTING
The following is the factory setting of the Key Operator Code
Number, which must be used to access the Key Operator
Program.
Factory setting = 00000
This number must be entered when accessing the Key
Operator Program for the first time. (See page 8-2.)
NOTE:
The Key Operator Code Number is an important security
number allowing the Key Operator to configure the copier’s
functions and auditor’s settings.
You should register your own code number — different from
the factory setting above — immediately after your copier is
installed.
★ KEY OPERATOR
Detach this page and store it in a safe place.
✂✂ ✂✂
✂
KEY OPERATOR’S GUIDE
Key operator code number: factory setting