78
CHANGING THE RESOLUTION
You can select the resolution as appropriate for the original type.
Sending an image in scan mode
This section explains how to set the resolution to "300X300dpi", which creates a clearer image than the default
resolution.
1 Place the originals.
When using the document glass, place the original with the
side to be scanned face down.
2 Select settings in the touch panel.
(1) Specify the destination.
For the procedures for specifying a destination, see
"CONVENIENT TRANSMISSION METHODS" (page
72).
(2) Make sure that the desired mode ([Scan] tab)
is selected.
(3) Touch the [Resolution] key.
(4) Touch the [300X300dpi] key.
(5) Touch the [OK] key.
3 Press the [START] key.
The side to be scanned
must be face up!
A4
Auto Auto
Auto
File
Quick File
Address Review
Send Settings
Address Entry
Address Book
Data EntryFaxInternet Fax USB Mem. Scan
Special Modes
Colour Mode
File Format
Resolution
Exposure
Original
Scan:
Scan
Send:
Text
200X200dpi
PDF
Auto/Greyscale
PDF
Scan/Resolution
OK
300X300dpi
200X200dpi
100X100dpi
400X400dpi
600X600dpi
(3)
(1)
(2)
(5)
(4)
Cancel scanning
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
