108
KEY OPERATOR PROGRAMS
Key operator programs
Program Page
Code No. Program Name Function No.
P27 Erase Width Sets the amount of the erase area. 118
Adjustment
P28 Initial Status Sets the copier’s initial settings in the ready 119
Setting condition.
P29 Total Copy Count Recalls the total copy counts of the copier, 119
document feeder, duplex section, and staple sorter.
P31 Preheat Mode Set the time that elapses before the copier enters 120
Setting the preheat mode after copying is completed.
P42 Right/Left Shift Determines whether shift direction change is to be 120
Direction Selection allowed.
P43 Erase Mode Sets the erase mode’s initial setting. 120
Initial Setting
P44 Restrict Storage Prevents insert pages from being stored in job 121
of Inserts in Job memory.
Program Memory
P45 Message Time Sets the length of time that messages are displayed. 121
Setting
P46 Require Key Prevents the copier from being started by people 121
Operator Code other than key operator.
P47 Stream Feeding Enables the stream feeding mode for copying 122
Mode from the document feeder.
P50 Staple Position Sets the initial stapling position setting for an 122
Setting optional 20-bin staple sorter (SF-S55N).
P51 Auto Front Access Enables or disables the front access mode for each 123
Mode Setting of sort, group, and staple sort modes when an
optional 20-bin staple sorter (SF-S55N) is installed.
P52 Override Sorter Bin Cancels limit control of operation in case of bin 123
Capacity Limit capacity overflow.
P70 Disabling of Auto Prevents automatic paper selection. 124
Paper Selection
P71 Disabling of Auto Prevents automatic switching between the paper 124
Tray Switching trays.
To Next Page
Loading...
