107
KEY OPERATOR PROGRAMS
Key operator programs
KEY OPERATOR PROGRAMS
A complete list of all key operator programs is provided below.
These programs can only be accessed by first entering the key
operator code number.
If an optional Card Counter (SF-EA11) or Auditor (SF-EA12) is
installed, key operator programs 10, 11, 13, 14, 16 and 18 cannot be
accessed by way of the copier keys. In this case, settings for auditing
programs must be selected by using an optional Counter
Commander (SF-EA13). The operation of the SF-EA11, SF-EA12,
and SF-EA13 auditing system is described in a separate manual.
Program Page
Code No. Program Name Function No.
P10 Auditing Mode Enables or disables the basic auditing mode, which 111
controls access to copier.
P11 Number of Copies Displays the total number of copies made against 111
per Account account numbers.
P13 Resetting Account Resets all audit accounts or selectively resets 111
individual accounts.
P14 Account Number Registers accounts, deletes accounts, changes 112
Control an account number, or displays all registered
account numbers.
P16 Account Limit Sets the maximum number of copies which can be 114
Setting made against a registered account number.
P18 Account Number Guards against trial and error entering of audit 115
Security account numbers.
P19 Key Operator Code Changes the key operator code number. 115
Number Change
P20 Auto Exposure Lightens or darkens copies in the automatic 116
Adjust exposure mode.
P21 Power Off Timer Sets a time interval after which the copier 116
automatically turns off.
P22 Toner Save Mode Reduces toner consumption. 116
P23 Auto Clear Setting Sets a time interval after which the copier returns 117
to the initial settings.
P24 Add or Change Adds or changes a reduction or enlargement 117
Extra Preset Ratio preset copy ratio.
P25 Setting a Maximum Sets the maximum number of copies that can be 117
Number of Copies selected.
P26 Initial Margin Shift Sets the initial margin shift values. 118
Setting
To Next Page
Loading...
