24
MAKING COPIES
COVERS
The COVERS mode is used to place covers on the front, back, or
both the front and back of multipage documents.
●
Front cover sheets can be copied on, but only on the front side
even in the 1-sided to 2-sided and 2-sided to 2-sided copy modes.
The back side of the original designated as the cover will not be
copied.
●
Back cover sheets cannot be copied on, either on the front side or
on the back side.
●
Cover sheets must be fed from the manual feed tray and must be
the same size as the copy paper being used to copy the
document.
●
When the COVERS mode is selected, the stream feeding mode of
the RADF will always be off. See page 8 for the stream feeding
mode.
1
Place the originals face up in the document feeder tray.
2
Press the COVERS/INSERTS key.
●
If the 1-sided to 1-sided mode was previously selected, the
following message will appear. Otherwise, the message in
step 3 will appear.
USE 10-KEY PAD TO SELECT ORIGINAL TO
COPY MODE. IT IS NOT POSSIBLE TO
CHANGE MODE AFTER THIS FUNCTION IS SET
1
//
//
/
1: 1
1
//
//
/
2
EVEN NUMBER ORIGINALS : 2
ODD NUMBER ORIGINALS : 3
2
//
//
/
2: 4
2
//
//
/
1: 5
3
Select the desired ORIGINAL TO COPY mode by
pressing key 1, 2, 3, 4, or 5 on the 10-key pad.
●
The selected item will be highlighted and then the following
message will appear.
Covers
COVERS AND INSERTS
USE 10-KEY PAD TO SELECT COVERS /
INSERTS MODE.
COVERS
: PRESS 1
INSERTS
: PRESS 2
COVERS+INSERTS
: PRESS 3
SORTER
COVERS/
INSERTS
MARGIN
SHIFT
ER
TRANSPARENCY
INSERTS
ORIGIN
123
456
7
8
9
C
0/
AUDIT CLEAR
To Next Page
Loading...
