UX178U-TSDM
RT
<P=001>
Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see "Caller ID" in
Chapter 7 for display messages related to Caller ID.
DOCUMENT JAMMED
The original document is jammed. See the following
section, "Clearing Paper Jams".
FUNCTION MODE The FUNCTION key has been pressed.
HOLD
The HOLD/SEARCH key has been pressed to put
the other party on hold during a phone conversation.
Press the HOLD/SEARCH again to take the other
party off hold.
LINE ERROR
Transmission or reception was not successful. Press
STOP to clear the message, and then try again. If the
error persists, see "Line Error" in "Problems and
Solutions" in this chapter.
LINE IS IN USE
An extension phone connected to the fax is being
used. Do not lift the fax’s handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.
NO DATA
This appears if you attempt to search for an
automatic dialing number when none have been
stored.
NO # STORED
You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn’t been programmed (a full
number hasn’t been assigned to it).
OUT OF PAPER
You have run out of fax paper. Load a new roll of fax
paper as described in "Loading the Fax Paper" in
Chapter 1.
ON HOOK DIAL
The SPEAKER key has been pressed and the fax is
waiting for you to dial. (To return to the date and time
display, press the SPEAKER key again.)
OVER HEAT
The print head has overheated. Operation can be
continued once it cools.
11.Trouble-
shooting
Display Messages
79
To Next Page
Loading...
Need help?
General
