Preparation
16
Installing the Lithium Memory
Battery
The supplied lithium battery is used to store the
memory of the date and time settings.
1 Slide the card slot cover release in the
direction of the arrow to open the card
slot cover.
2 Pull out the lithium battery holder using
the tip of a ballpoint pen or other pointed
object.
3 Insert the lithium battery into the holder
with the = side of the battery facing the
+ side of the holder.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recom-
mended by the equipment manufacturer.
WARNING KEEP THIS BATTERY AWAY FROM
CHILDREN. IF SWALLOWED, CONSULT A
PHYSICIAN IMMEDIATELY FOR EMERGENCY
TREATMENT.
CAUTION BATTERY MAY EXPLODE IF MIS-
USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
4 Insert the lithium battery holder back into
the compartment.
5 Close the card slot cover.
Note:
• It is recommended to immediately set the date
and time after inserting a lithium battery. Not
setting the date and time causes extra wear of
the lithium battery.
Removing the lithium battery
Perform steps 1 and 2 above, and then lift out
the lithium battery from the battery holder.
Note:
• Replace the battery with a new CR2025 lithium
battery when the time indicator of the camcorder
starts to fall behind the correct time.
Notes on the Use of the Lithium
Battery
• Do not short-circuit, recharge, disassemble,
or heat the lithium battery.
• Should the lithium battery leak, wipe the
battery compartment and holder clean, and
then insert a new battery.
• The lithium battery will last about one year
under normal usage.
Card slot cover
release
Lithium battery holder
+ mark
To Next Page
Loading...
