Useful Features
Playback
Useful
Features
47
Control Buttons on the Infrared Remote Control
1 Open the LCD monitor to a 90° angle to
the camcorder body (1), and then
rotate it 180° vertically (2).
2 Set the Media Selection switch on the
camcorder to TAPE, DUAL, or CARD.
3 Set the POWER switch on the camcorder
to CAMERA or VCR.
Operating the Infrared Remote Control
4 Aim the remote control transmitter at the
infrared remote sensor of the camcorder,
and press the control buttons for
operation.
Notes:
• Be careful not to allow direct sunlight or bright
light from interior illumination to fall onto the
remote sensor, as this may prevent the remote
control from operating properly.
• Be sure that there are no obstacles between the
remote control and the remote sensor.
1
2
180
90
Infrared remote
sensor
Approximate operating
range of remote control
Transmitter
5 m
TAPE REC START/STOP
button [pp. 23, 39]
ZOOM T/W buttons [pp. 24, 54]
CARD REC button [pp. 39, 72]
REW button [pp. 26, 27]
PAUSE/STILL button [p. 27]
STOP button [p. 26]
Playback Direction buttons
[p. 48]
VOL. =/- buttons [p. 27]
PLAY button [p. 26]
FF button [pp. 26, 27]
SLOW button [p. 48]
Shift buttons [p. 53]
To Next Page
Loading...
