Sharp XE-A213

58
6. Position of decimal point programming (Press
s
to skip. / Press
A
to terminate.)
7. Terminate programming
Item: Selection: Print:
A Open rate entry Enable* 0
Disable 1
B Preset rate entry Enable* 0
Disable 1
C TAB (position of decimal point from right) 0-3 (default:2)
Programming for
r
,
o
,
X
,
Y
,
c
and
b
The
X
key is used as an example below.
Programming for
r
and
o
, the step 3 and 4 are skipped.
1. Specify the key to program.
2. Text programming (Press
s
to skip. / Press
A
to terminate.)
ENTER TEXT
CHECK1
:
(1) Press
:
key to enter text programming.
Immediately after displaying guidance message, the
current text data will be displayed.
CH1 PROGRAMMING
ENTER[00]KEY
X
(1) Press the
X
key to enter
X
programming.
Immediately after displaying "CH1 PROGRAMMING",
guidance message for the next step will be displayed.
Operator displayKey operation
From left, ABC
Rate
Text
Print
0.00
A
(1) Press the
A
key to terminate the
V
key
programming.
ENTER[TL/NS]KEY
s
(2) Press the
s
key to register the setting.
2
2
(1) Enter the position of decimal point from right using
numeric key.
The position of decimal point from right can be set
from 0 to 3.
Default setting is 2.
TAB
2
s
(2) Press the
s
key to register the setting.
Immediately after displaying guidance message for
the next step, the current setting for the next step
will be displayed.
A213_3 FOR THE MANAGER(SEEG) 06.4.28 8:33 PM Page 58