79
Part3
FOR THE MANAGER
Part2Part1
TRAINING MODE
The training mode is used when the operator or the manager practices register operations.
When a clerk in training is selected, the machine automatically enters the training mode. To specify a clerk to be
trained, refer to “Training clerk specification for training mode” in “ADVANCED FUNCTION PROGRAMMING” in
page 74.
The training operation is valid only in REG, MGR and mode.
The corresponding clerk memory is only updated in the training mode.
A clerk set in training
20 L
1000 '
3 @
#
A
PrintKey operation example
A213_3 FOR THE MANAGER(SEEG) 06.4.28 8:33 PM Page 79
To Next Page
Loading...
