Sicam SBM 855 - Maintenance; Lubricants and Servicing; Condensate and Oil Maintenance; Spare Parts Information

656 229 2010-11-22| Sicam snc società unipersonale
44 | SBM 855 | Maintenanceen
12. Maintenance
12.1 Recommended lubricants/oil mist
lubricator
Component Lubricant Standard
Compressed air system ESSO FEBIS K 32 ISO 32
Tab. 2: Lubricant table
! The manufacturer cannot accept any liability for da-
mage arising from the use of other lubricants.
12.2 Cleaning and servicing
!
Before cleaning and servicing, switch off SBM 855
and disconnect mains plug.
! Do not use any solvent-based cleaning agents. Use
alcohol or similar cleaning agents for plastic parts.
The following work is essential to ensure proper opera-
tion and high performance of the SBM 855:
12.2.1 Service intervals
Servicing
Weekly Once a year
Clean moving mechanical parts, treat with spray oil
or kerosene and lubricate with engine oil or
a suitable grease.
x
Remove condensate.
x
Check the oil level in the oil mist lubricator.
x
Replace the oil in the oil mist lubricator.
x
Tab. 3: Service intervals
12.2.2 Removing condensate
1. Turn the red knob at the bottom of the water separa-
tor counter-clockwise.
2. Remove the accumulated condensate.
3. Turn back the red knob at the bottom of the water
separator.
12.3 Spare and wearing parts
The manufacturer cannot accept any liability for
damage arising from the use of non-genuine replace-
ment parts.
Designation Order number
Standard centering flange 602 400
Quick-action clamping nut 616 200
Centering cone 42 - 64,5 mm 632 500
Centering cone 54 - 79,5 mm 652 862
Centering cone 74 - 111,5 mm 605 600
Weight pliers 606 500
Manual vernier caliper 629 400
Test clip 602 700
Calibration weight 654 377
Calibration weight (calibrated) 654 376
Voltage sticker 100 789
Direction of wheel rotation sticker 653 878
Tab. 4: Spare and wearing parts
12.2.3 Topping up oil in oil mist lubricator
1. Remove the compressed air connection.
2. Screw the container to the oil mist lubricator.
3. Top up with oil.
651003-12_Rf
12.2.4 Replacing oil in oil mist lubricator
1. Remove the compressed air connection.
2. Screw the container to the oil mist lubricator.
3. Drain off and dispose of the oil.
4. Fill with fresh oil.