SICE S 63 E - GENERAL CONFIGURATIONS - SET UP

116 S 63 E - S 63 E C Operator's Manual
14. WHEEL SPIN COUNTER
This programme is used to display the total number of spins performed by the machine since its
first start-up (tot SPi), the number of spins performed since the last unbalance calibration (CAL
SPi) and the number of partial spins performed since the machine was last started (PAr SPi).
Proceed as follows to recall this programme:
• press the key
• use the keys to search for -SP in-
• Press the key to display the total number of spins performed by the machine since
its first start-up (tot SPi)
• Press the key to display the number of spins performed since the last sensitivity
calibration (CAL SPi). It is reset at each new calibration.
• Press the key to display the number of spins performed since the last sensitivity
calibration (PAr SPi). It is reset each time it is turned off.
• press the key to exit.
15. GENERAL CONFIGURATIONS - SET UP
The machine can be configured according to your requirements. The following configurations
are available:
- Selecting vehicle type (car – motorcycle)
- Unbalance unit of measurement
- Unbalance rounding-off
- Automatic search for RPA position
- Warning OPT
- Rim diameter display unit of measurement
- Rim width display unit of measurement
- Beeper
- Setting - Application position for adhesive weights
- Display brightness setting
- LED light
- Laser indicator