SICE S 63 E - Transport, Storage and Handling

Operator's Manual S 63 E - S 63 E C 75
TRANSPORT, STORAGE AND HANDLING
Handling prior to installation
The basic wheel balancer packaging consists of 1 wooden crate containing:
- the wheel balancer (Fig.8)
- equipment;
- the wheel guard and corresponding mounting tube (C, Fig.4a - D, Fig. 4a).
Before installation, the wheel balancer must be shipped in its original packaging, making
sure that the machine is maintained in the position indicated on the outer packaging.
The machine can be moved by placing the packaging on a wheeled trolley or inserting
the forks of a fork lift truck in the relative slots in the pallet (Fig. 1).
1
- Packaging dimensions:
Length Depth Height Weight Packaging weight
(mm) (mm) (mm) (kg) (kg)
1410 890 1260 152 (vers. NO C) 80
156 (vers. C)
- The machine must be stored in an environment meeting the following requirements:
• relative humidity ranging from 20% to 95%;
• temperature ranging from -10° to +60°C.
WARNING
Do not stack more than two packs to avoid damaging them.
The machine may be moved after installation by inserting the forks of a lift truck under
the machine itself, with centre line between the forks approximately aligned with the