SICE S 63 E - Page 132

132 S 63 E - S 63 E C Operator's Manual
no no
- This message is displayed if the wheel is balanced on the outer side
in -1-
- This message indicates that the machine is set for acquiring the P1 posi-
tion behind the first spoke
in -2-
- This message indicates that the machine is set for acquiring the P2 posi-
tion behind the second spoke
no -2-
- This message is displayed for approx. 3 seconds if the selected angle is
greater than 120 degrees, indicating that the procedure must be repeated
correctly
in H.X
- This message indicates the reference for acquiring the two points P1
and P2 behind the spokes. Depending on the configuration made by
the operator, the message shown on the right-hand display may be H3,
H6 or H12. If the laser indicator is enabled, the reference is the 6 o'clock
position (H.6)
CAL GO
- Calibration spin
I - - CAL
- This message indicates the correct position for applying the calibration
weight in the unbalance calibration programme at the end of the first spin
-- I CAL
- This message indicates the correct position for applying the calibration
weight in the unbalance calibration programme at the end of the second
spin
End CAL
- This message indicates the end of the unbalance calibration programme
GO ALU
- Spin with ALU programme selected
GO d15
- Spin with Motorcycle Dynamic programme selected
GO A15
- Spin with Motorcycle ALU programme selected
St
- Spin with Static programme selected (car/motorcycle environment) or
when the Static balancing programme is selected in the vehicle working
environment
St biE
- This message indicates the selection of the Static balancing programme
in the motorcycle working environment
dyn biE
- This message indicates the selection of the dynamic balancing programme
in the motorcycle working environment
ALU biE
- This message indicates the selection of the ALU balancing programme in
the motorcycle working environment
ccc ccc
- Unbalance values greater than 999 grams
-1A
- This message indicates the Inner Plane for applying the adhesive weight
in the ALU 1P balancing programme
A-2 ---
- This message indicates the External Plane for applying the adhesive
weight in the ALU 1P/ALU 2P balancing programme