CONTENTS
3
OPERATING INSTRUCTIONS | DUSTHUNTER SB30
8014551/1COY/3-0/
2016-08 | SICK
Subject to change without notice
1 Important Information .............................................................................. 6
1.1 Main hazards...................................................................................................6
1.1.1 Hazard through hot and/or aggressive gases and high pressure 6
1.1.2 Hazards through electrical equipment ..........................................6
1.1.3 Hazards through laser beam..........................................................6
1.2 Symbols and document conventions ............................................................. 7
1.2.1 Warning Symbols ...........................................................................7
1.2.2 Warning levels and signal words....................................................7
1.2.3 Information symbols .......................................................................7
1.3 Intended use ................................................................................................... 7
1.4 Responsibility of user......................................................................................8
1.4.1 General information........................................................................ 8
1.4.2 Safety information and protective measures ................................8
2 Product Description.................................................................................10
2.1 Measuring principle, measured variables....................................................10
2.1.1 Functional principle ......................................................................10
2.1.2 Response time ..............................................................................11
2.1.3 Function check..............................................................................12
2.2 Device components ......................................................................................13
2.2.1 Sender/receiver unit ....................................................................15
2.2.2 Flange with tube ...........................................................................17
2.2.3 Optional external purge air unit ...................................................18
2.2.4 Voltage and purge air supply........................................................18
2.2.5 Installation accessories................................................................18
2.2.6 Test equipment for linearity test..................................................19
2.3 SOPAS ET (PC program) ................................................................................20
3 Assembly and Installation ......................................................................21
3.1 Project planning ............................................................................................21
3.2 Assembly .......................................................................................................23
3.2.1 Fitting the flange with tube ..........................................................23
3.2.2 Work to be performed...................................................................24
3.2.3 Fitting the optional external purge air unit. .................................25
3.2.4 Assembly work ..............................................................................26
3.2.5 Fitting the weatherproof cover .....................................................27
Contents
Contents
To Next Page
Loading...