SICK DUSTHUNTER SB30

60
OPERATING INSTRUCTIONS | DUSTHUNTER SB30
8014551/
1COY/3-0/2016-08| SICK
Subject to change without notice
7 SPECIFICATIONS
7Specifications
7.1 Compliances
The technical design of this device complies with the following EU directives and EN
standards:
● EU Directive: LVD (Low Voltage Directive)
● EU Directive: EMC (Electromagnetic Compatibility)
Applied EN standards:
● EN 61010-1, Safety requirements for electrical equipment for measurement, control
and la
boratory use
● EN 61326, Electrical equipment for measurement technology, control technology and
laborat
ory use - EMC requir
ements
● EN 14181, Stationary source emissions - Quality assurance of automated measuring
sy
stems
Electrical protection
● Insulation: Protection class 1 according to EN 61010-1.
● Insulation coordination: Measuring category II according to EN 61010-1.
● Contamination: The device operates safely in an environment up to degree of contami-
nation 2 according to EN 61010-1 (usual, not conductive contamination and temporar
y
conductivity b
y occasional moisture condensation).
● Electrical energy: The wiring system to the power supply voltage of the system must be
installed and fused
according to the relevant regulations.
Approvals
The DUSTHUNTER SB30 version is TÜV type-tested.
CAN-Bus