6
OPERATING INSTRUCTIONS | DUSTHUNTER SB30
8014551/
1COY/3-0/2016-08| SICK
Subject to change without notice
1 IMPORTANT INFORMATION
1 Important Information
1.1 Main hazards
1.1.1 Hazard through hot and/or aggressive gases and high pressure
The optical subassemblies are fitted directly on the gas-carrying duct. On equipment with
low hazard potential (no danger to health, ambient pressure, low temperatures), the instal-
lation or removal can be performed while the equipment is in operation providing the valid
regulations and equipment safety notices are observed and suitable protective measures
are taken.
1.1.2 Hazards through electrical equipment
1.1.3 Hazards through laser beam
WARNING: Danger through power voltage
The DUSTHUNTER SB30 measuring system is classified as electrical.
▸ Disconnect power supply lines before working on power connections or
par
ts carrying power voltag
e.
▸ Refit any contact protection removed before switching the power voltage
back on again.
WARNING: Hazards through laser beam
▸ Never look directly into the beam path
▸ Do not point the laser beam at persons
▸ Pay attention to laser beam reflections.
To Next Page
Loading...