39
OPERATING INSTRUCTIONS | DUSTHUNTER SB30
8014551/1COY/3-0/
2016-08| SICK
Subject to change without notice
START-UP AND PARAMETER SETTINGS 4
4.2.2.1 Setting measuring range and limit value
▸ Plug the jumper in the slot for the setting desired for the measuring range and limit
value.
Fig. 21: Slots on processor board
Parameter
Slot 1 Slot 2 Slot 3 (default)
Value at LZ
0 SI 0 SI 0 SI
Value at MBE
30 SI 500 SI 3000 SI
Limit value
15 SI 250 SI 1500 SI
Slot 4 is not used.
Slots for setting
the measuring
range and limit
value
Slots for
addressing
Slots for set-
ting the CAN
bus baud rate
To Next Page
Loading...