43
OPERATING INSTRUCTIONS | DUSTHUNTER SB30
8014551/1COY/3-0/
2016-08| SICK
Subject to change without notice
START-UP AND PARAMETER SETTINGS 4
4.2.5 Connection to the device via Ethernet (option)
Recommended procedure:
1 The MCU must be switched off.
2 Connect the MCU with the network.
3 Connect the PC to the same network.
4 Switch the MCU on.
5 Start SOPAS ET.
6 “Search settings”
7 “Device family oriented search”
8 Click the desired MCU
9 Make the settings:
– Ethernet communication (always clicked)
– USB communication (always clicked)
– Serial communication: Do not click
10 Specify the IP addresses
IP address: see “Setting the Ethernet module parameters”, page 50
11 Do not click a COM port
12 Assign a name for this search
13 “Finish”
To connect to the measuring system via Ethernet, the Ethernet interface module must
be installed on the MCU and the parameters set.
To Next Page
Loading...