SICK FLOWSIC100 Flare Addendum To Operating Instructions

10 FLOWSIC100 Flare · Addendum to Operating Instructions · 8025365/V1-0/2020-05 · © SICK Engineering GmbH
For your safety
2. 1
Basic safety information
Observe the safety information here and the warning information in the following Sections
of this document and the FLOWSIC100 Flare Operating Instructions to reduce health risks
and avoid dangerous situations.
▸ Read the FLOWSIC100 Flare Operating Instructions and this document before putting
the FLSE100-XT sender/receiver units into operation.
▸ Observe all safety information.
▸ If there is something you do not understand: Contact SICK Customer Service.
▸ Only use the FLSE100-XT sender/receiver units as described in this document. The
manufacturer bears no responsibility for any other use.
▸ Do not carry out any work or repairs on the FLSE100-XT sender/receiver units not
described in this manual.
▸ Do not remove, add or modify any components to or on the FLSE100-XT sender/
receiver units unless described and specified in the official manufacturer information.
▸ If you do not observe this:
– Any warranty by the manufacturer becomes void,
– the device could become dangerous
– the approval for use in potentially explosive atmospheres is no longer valid.
▸ Do not use damaged components or parts.
Special local requirements
Follow all local laws, regulations and company policies applicable at the respective installa-
tion location.
2. 2 Intended use
FLSE100-XT sender/receiver units may only be used to measure the gas velocity, gas
volume, mass flow and molecular weight in pipelines.

SICK FLOWSIC100 Flare Specifications

General

Brand	SICK
Model	FLOWSIC100 Flare
Category	Measuring Instruments
Language	English