SICK FLOWSIC100 Flare - Page 86

86 FLOWSIC100 Flare · Addendum to Operating Instructions · 8025365/V1-0/2020-05 · © SICK Engineering GmbH
Annex
10 .1
Compliances of FLSE100-XT sender/receiver units
10.1.1 Compliances
10.1.2 CE declaration
The FLSE100-XT sender/receiver units have been developed, built and tested according to
the following EU Directives:
● ATEX Directive 2014/34/EU
● EMC Directive 2014/30/EC
Conformity with the above Directives has been determined and the CE label attached to the
device.
10.1.3 Standards compatibility and type approval
The FLSE100-XT sender/receiver units comply with the following Norms, Standards or
recommendations:
● IEC 60079-0: 2015, IEC 60079-1: 2014, IEC 60079-7: 2015,
● IEC 60079-11: 2011 + Cor. 2012, IEC 60079-15: 2010, IEC 60079-26: 2014,
● IEC 61010-1: 2010 + Corr. 2011 and comparable European Standards and comparable
ANSI/UL or CSA Standards
● EN 60079-0:2012, EN 60079-1:2014, EN 60079-7:2015, EN 60079-11:2012,
EN60079-15:2010
● EN 60079-26:2015, EN 60079-28:2015, EN 61326-1:2013
● EN 61010-1 (Safety requirements for electrical equipment)
● EN 60529: 1991/A1:2000/A2:2013 (IP)
NOTICE:
Applied European standards and harmonized standards are listed in the valid
version of the manufacturer‘s CE conformity declaration.