SICK Inspector PIM60 User Manual

CommentBinaryRangeAttributeValue tagContainer tag
in the Ethernet Result output dia-
log.
Pattern matching score.REAL[0, 100]SCORE
0=not found, 1=found, 2=Out-
side image
USINT{0, 1, 2}DECISION
Name attribute required if
more than one Polygon exists
any stringnamePOLYGON
Number of corners used for
this polygon tool.
USINT[2, 16]NUM_
CORNERS
0=not found, 1=defect, 2 =
pass
USINT{0, 1, 2}DECISION
Polygon matching score.REAL[0, 100]SCORE
Number of defect pixels inside
crack detection region in poly-
UDINTNUM_
PIXELS
gon. Undefined for single edge
tool.
0=polygon completely inside
image, 1=one or more polygon
USINT{0,1}CORNER_
OUTSIDE
corner(s) are outside image.
Cannot be used for single edge
tool.
Coordinate of the first found
pixel that was within the defect
REALcoordUnitDEFECT_X
thresholds. In “pixels” or “mm”
depending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
Return -1 if defect detection is
not active or no defect found.
Undefined for single edge tool.
Coordinate of the first found
pixel that was within the defect
REALcoordUnitDEFECT_Y
thresholds. In “pixels” or “mm”
depending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
Return -1 if defect detection is
not actived or no defect found.
Undefined for single edge tool.
"All"
b
iterates over all polygon
corners. Number 0 to 15 gives
{0, 1,
...,15, all}
cornersCORNERS
a
the properties of a single
corner. The index of this corner
is the order in which the poly-
gon corner was added when
the polygon was drawn.
Polygon corner coordinate. In
“pixels” or “mm” depending on
REAL
c
REALcoordUnitX
attribute “coordUnit” or con-
8015726/2013-11
©SICK AG • Advanced Industrial Sensors • www.sick.com • All rights reserved
Subject to change without notice
42
Reference Manual
Result output formatting
Appendix
Inspector PIM

SICK Inspector PIM60 Specifications

General

Brand	SICK
Model	Inspector PIM60
Category	Accessories
Language	English