Angle tool result output
Result Output
Decision OK/Not OK/Invalid/Neutral/Not found.
Angle Angle in degrees.
Select the Angle checkbox to use the angle as a
Pass/Fail-condition.
GUI operations
Use the Switch features button ( ) to switch Feature A and Feature B.
Use the Select features button ( ) to enable or disable selection of features in the
image area.
7.6.14 Application example: Counting chocolates
The following steps describe how to use tools to count the number of chocolates in a
box. Images from the TriSpector1030 emulator are used for the analysis.
1. Start the TriSpector1030 emulator in SOPAS ET. For instructions on how to start
the emulator, see "Starting the emulator", page 54.
✓
The SOPAS ET device window opens.
2. Go to the Image workflow step and check that chocolate box images are displayed
in the image area according to figure 27.
Figure 27: TriSpector1030 emulator image
3. Go to the Task workflow step.
4. Click Save job image to switch to the job image view where the tool groups are
shown.
5. In the Find tool group, click Shape to apply a Shape tool to the job image.
6. Move and resize the region of interest for the Shape tool to cover the chocolate box.
Leave some extra space between the object and the region borders. See figure 28.
OPERATION
7
8021808/12ID/2019-01 | SICK O P E R A T I N G I N S T R U C T I O N S | TriSpector1000
41
Subject to change without notice
To Next Page
Loading...
