Alphabetical Reference Description of functions
62
Default Route
• Enter the Æ IP address that was assigned to your Æ PBX if no
Æ DHCP server assigns this value dynamically.
• If the value was assigned dynamically, it can only be read.
• A restart is necessary after the change.
•Standard value Æ page 96.
• IP editor in the optiPoint 410/420 Æ page 93.
Æ page 22 Æ page 17 Æ page 52
Default SNTP IP
• This entry is only required if you selected "SNTP" in the Æ Time Source
field.
• Enter the Æ IP address of the Æ SNTP server.
Æ page 57
Default VLAN ID
• Can be defined only if the Æ Layer 2 support is activated Æ QoS L2/L3.
• Enter a value from 0 to 4095 here. This value describes the association
with a certain VLAN, if a Æ VLAN is used.
Æ page 22 Æ page 17 Æ page 52
DHCP
• Activate this option if the required IP data of the telephone should be
assigned dynamically by a Æ DHCP server.
• If no DHCP server is available in the IP network, please deactivate this
option. In this case, the data corresponding to the Æ Terminal IP Ad-
dress, Æ Te r mina l Ma s k and Æ Default Route must be defined manu-
ally.
• A restart is necessary after the change.
•Standard value Æ page 96.
Æ page 21 Æ page 17 Æ page 52
Display Test
• Conduct this test to check the function of the Æ LCD display in the Dis-
play telephone.
• Different display contents are displayed with the
< and > keys.
Æ page 25
DLS Server Port
• Enter the Æ Port-Number for communication with the Æ DLS-Server .
Æ page 56
DLS Server Address
•Enter theÆ IP address of the Æ DLS-Server.
Æ page 55
To Next Page
Loading...
