Siemens 2000

Description of functions Alphabetical Reference
61
Compression
• Chose the compression mode which has to be used, if Æ Codec „Lo-
Band“ was selected (Æ G.723 oder Æ G.729).
•Standard value Æ page 96.
Æ page 49
Compressing Codec Threshold Values
•Packed Æ Codec
• Lost packet thresholds [in Promille]: Packets which got lost for voice
decoding. This value is the proportion from lost packets to total number
of packets.
– Valid values: 1 ... 255
–Standard value Æ page 96.
• Consecutive lost packets [in Packets]: the lost packets in serial be-
tween two good packets will be counted. If the amount of the counted
packets is higher than the entered value the threshold will be exceed-
ed.
– Valid values: 1 ... 255
–Standard value Æ page 96.
• Consecutive good packets (aufeinanderfolgend verarbeitete Pakete [in
Paketen]): the good packets in serial between two bad packets will be
counted. If the amount of the counted packets is lower than the en-
tered value the threshold will be exceeded.
– Valid values: 1 ... 255
–Standard value Æ page 96.
Æ page 54
Daylight saving
• This entry is only required if you selected "SNTP" in the Æ Time Source
field.
• Activate this field if you want the clock on your telephone to automati-
cally switch between daylight saving and standard time.
Æ page 57
Debug Interface
• Only necessary for development. However, this function can be used
for debugging customer systems in an emergency.
• If this field is activated, the WindRiver Tornado debugger contacts the
telephone and allows the software to be debugged.
Æ page 56