3 Setting up functions 03/2013
3.2 Configuring measurements and measurement series
© Siemens AG 2006-2013 All Rights Reserved
3-108 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3.2.4 Performing test series
Overview
Test series are used to automate measurements for condition monitoring to a great
extent. A test series can contain any number of measurement series. These
measurement series are performed one after the other in the defined order when a
test series is run. An machine operator is only required at the machine for the
purpose of starting the test series.
The measurements are made and measurement results stored without any further
operator actions.
Function description
Fig. 3-16: Changing the configuration of a test series
The following entries have to be made to configure a test series:
Function Description Type
Name Name of the test series. The system suggests
an automatically generated name, which you
can change. The names of test series must be
unique within the context of the machine. The
system adds another element to the name
automatically if the name entered by the
machine operator has already been assigned to
another test series.
INPUT
Channel Selection of the required channel. SELECTION
Comment Text that can be freely entered for a detailed
description of the test series.
INPUT
To add, remove, or change the sequence of measurement series, these are
selected in the overview displayed and moved by dragging and dropping or using
the arrow buttons on the form.
A test series can only contain measurement series in one channel. It is not possible
to change the channel of a test series.