03/2013 2 Machine information
2.6 Remote access
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
2-85
2.6 Remote access
Overview
Remote access is an efficient and low-cost way of providing support for machine
tools and production equipment via the Internet.
In the event of a fault, the service organization of the machine manufacturer has
fast access to important machine control data and diagnostic functions. In that way,
the machine manufacturer or maintenance department of the end user can
immediately analyze the current condition of the machine in which a fault occurred.
Remote access avoids time-consuming on-site service assignments or at least
helps prepare for them better. Machine manufacturers can therefore reduce their
warranty costs while providing more efficient service support for their end users.
If a connection already exists to the machine, then the system automatically
identifies which remote access has been installed.
Fig. 2-58: Selecting remote access via Access MyMachine
References
Further information on installation and application can be found in the following
documentation:
Software Installation Manual: SINUMERIK Integrate MMT, MMP, AMB, AMC,
AMM, AMP
Operating Manual: SINUMERIK Integrate MMT, MMP, AMC, AMM, AMP
To Next Page
Loading...
Need help?
General
